Hi i was going to take the wheel and etc... off however as its raining i thought i would ask here before getting wet? I read somewhere on one of the forumns that it was 30mm can anyone confirm please?
be care putting the on, can damaged easy, also make sure there are knocked right down as i fort mine was and i hand spun the wheel as was touching abs sensor.
J, how did you go about putting them on? I see elDude used a press and his nylon block.
I wasn't sure to use the pad spreader and clamp it down some how as I thought hammering wasn't an option? If it comes to it i will just have to remove the hubs and get a local garage to put them on.
ok ive never done this my self before, but i had a idea...... all i did was copper gress the abs ring and slide it on the hub then use the old abs ring line the teath up and using a rubber hammer taping it on. before you tighten up the hub nut make sure it done touch the sensor, i had to keep taking it off and taping it, they are really close to senor but you can see and when you spin the wheel. hope this help mike.