Pin?
Fri Nov 12, 2010 10:14 pm
Hi,
I have a piece to buy for my FRP, and I would like to know if it is the same as standard Puma or not. I don't know the english name of that piece (maybe a pin?), so I put a picture of it:
(It is not a pictures of my Puma)
So, are they the same as the Puma in the front and the rear?
Thanks!
I have a piece to buy for my FRP, and I would like to know if it is the same as standard Puma or not. I don't know the english name of that piece (maybe a pin?), so I put a picture of it:
(It is not a pictures of my Puma)
So, are they the same as the Puma in the front and the rear?
Thanks!
Re: Pin?
Fri Nov 12, 2010 11:51 pm
I can not see the image.
Can either call it Part Number or Finis Code.
Can either call it Part Number or Finis Code.
Re: Pin?
Fri Nov 12, 2010 11:58 pm
Wheel stud,
M12 x 1.5mm, I must have 8 knocking about in the shed, as I fitted longer ones for the wheel spacers.
I'm pretty sure they are standard Puma / Ford parts.
Just hit hard with a mallet and they come out the back.
Pull the new one in using a a few washers and the nut.
M12 x 1.5mm, I must have 8 knocking about in the shed, as I fitted longer ones for the wheel spacers.
I'm pretty sure they are standard Puma / Ford parts.
Just hit hard with a mallet and they come out the back.
Pull the new one in using a a few washers and the nut.